Before Starting to Use
Preparing to Print
22
z
For ordinary paper with images
lopsided on page
Press to open the two Paper Arrangers on the
more heavily printed side.
z
For thick paper
Press to open the two Paper Arrangers (right
and left) closer to the machine.
5
Adjust the Paper Jumping Wing.
(For RZ2XX, unavailable)
Adjust the Paper Jumping Wing Adjustment Dial
according to the type and width of the paper as it
is inserted into the machine.
z
For ordinary paper widths larger than
Letter, or equal to or larger than B4
Set to
Ledger or
A3 B4.
z
For ordinary paper widths that are either
equal to or smaller than Letter or that are
smaller than B4
Set to
Legal Letter Statement or
A4
B5.
z
For thick paper
Set to
.
Before Starting to Use
Preparing to Print
23
Note:
• When closing the Paper Receiving Tray, first
slide the Paper Stopper to the edge of the tray
and fold it inward. Then widen the Receiving
Tray Paper Guides with the Paper Arrangers
closed and fold the guides inward.
6
Set the corrugators.
(for RZ3XX, unavailable)
Lower the corrugators to the inside of the Paper
Guides.
Note:
• Usually the corrugators should be lowered.
When using thick paper, you need not lower the
corrugators.
Note:
• When closing the Paper Receiving Tray, first
slide the Paper Stopper to the edge of the tray
and fold it inward. Then raise the corrugators,
widen the Receiving Tray Paper Guides, and
fold the guides inward. Last close the Paper
Receiving Tray.
Riso Kagaku Technical Training Center Version
