Basic Operations
Basic Process
26
Basic Process
The machine presents two basic operational processes; master-making process and printing process.
z
Process for printing from a paper document or book
A placed original is scanned by the scanner, and a generated master is rolled around the Print Cylinder(Drum).
After a while, sample copy is performed. After checking the print result, enter the number of copies to be printed
and start printing.
z
Process for printing with data generated using a computer
Data sent from a computer is transformed into images, and a generated master is rolled around the Print Cylin-
der(Drum).
You can send instructions for printing from the computer (through the printer driver).
Important!:
• Some optional kits are needed for connection with a computer.
)
p.14
Basic Operations
Basic Operations
27
Basic Operations
Printing from a Paper Document or Book
1
Set the power switch to
(ON) to
turn the power on.
The power switch is located on the lower right side
of the machine.
: Power On
: Power Off
Important!:
• When the machine is in the Energy Saving
mode, the
key is lighted. Press the
key to
wake up the machine.
Note:
• If data is received from a computer while the
machine is being operated, that data may be
given a higher priority for making a master. To
give a higher priority to an original placed on the
machine, press the
key to turn off its indica-
tor.
2
Check the display.
Check that any Check & Error Display section is
not lighted or blinking.
Note:
• When the
indicator is lighted, idling action is
activated just before the master-making opera-
tion.
3
Place an original.
z
When placing on the Stage Glass
Open the Stage Cover and place the original
face down. Align the center of the original with
the mark on the left-hand side of the glass.
After placing the original, slowly close the
Stage Cover.
Note:
• When placing an original is completed, the
master-making process is automatically
started; the Master-Making indicator on the
Control Panel lights. If the indicator is not
lighted, press the
key.
z
When placing in the ADF unit
(Option)
Place originals face down, and then adjust the
ADF Original Guides to the width of the origi-
nals.
Important!:
• The sizes of originals to be placed in the
ADF unit must be 3
9
/
16
"
×
5
1
/
2
"(90 mm
×
140
mm) at least. For smaller originals, use the
Stage Glass.
Riso Kagaku Technical Training Center Version
