MAINTENANCE
Re-Tensioning Roller Assembly
WARNING / AVERTISSEMENT
Spring under tension.
DO NOT unwind the roller spring!
Ressort sous tension.
NE PAS dérouler le rouleaux à ressort!
The spring roller assembly comes from the factory
pretensioned In normal use, the roller assembly will
not need adjusting or re-tensioning Use the following
procedure only if the roller assembly is allowed to unwind
1 Find a medium sized screwdriver to help hold tension
on the assembly when the spring is wound
2 Ensure both ends of the roller assembly are securely
held in the roller holder
3 Find the label on the roller indicating the direction the
roller will need to be wound
4 Wind the roller 15 revolutions in the direction indicated
NOTICE
DO NOT
wind the roller assembly more than 18
revolutions or damage to the torsion spring will occur
5 While holding tension on the roller assembly, insert
the screwdriver into the small hole on the top of the
roller assembly and down into 1 of the 2 holes in the
roller tube Make sure the screwdriver is inserted
securely before letting go of the roller tube
6 Insert the back side of the curtain through the slot in
the storage support post and install the curtain on the
roller tube with the touch and hold fastener Center
the curtain vertically The reinforcement straps on
the curtain should be visible from the inside of the
Dok-Guardian
7 With 1 person supporting the curtain, remove the
screwdriver that is holding the spring tension Allow
the curtain to slowly and carefully roll around the roller
until the pockets for the retaining bar touch the roller
Insert the screwdriver in the hole to hold tension on
the spring assembly
8 Insert the retaining bar into the pockets in the curtain
Center the retaining bar on the curtain vertically
Position the retaining bar to the back side of the
pockets and self drill/tap screw through the curtain
top and bottom strap into the retaining bar to hold the
retaining bar securely attached to the curtain
9 Remove the screwdriver and carefully allow the
curtain to continue to roll up
Dok‑Guardian™ LD Safety Barrier
Installation/Service/Owner's Manual
Rite‑Hite
®
18 Publication:
AMEN00150 2019-11-13
