INSTALLATION
Curtain
WARNING / AVERTISSEMENT
Spring under tension.
DO NOT unwind the roller spring!
Ressort sous tension.
NE PAS dérouler le rouleaux à ressort!
Adjustment
Curtain must be adjusted after posts are secured in place
1 Loosen the bolts slightly on the latch bracket and
slide the latch bracket towards the storage post until
it stops
2 At the storage post, grasp the steel handle of the
curtain lead bar and walk the curtain across the
opening
3 Secure the curtain lead bar into the latch bracket on
the receiver post
4 Return to the back side of the storage post
If the round retaining bar is installed in the closest
available set of pockets to the units slotted opening,
go to
"Latch Bracket Adjustment" on page 10
"Moving Retaining Bar" on page 9
Moving Retaining Bar
A
B
1 Working from the back side of the storage post,
mark the roller tube at top of the curtain for vertical
placement
2 Backwind the roller tube Lock the roller with a
screwdriver, by inserting the screwdriver through
the hole in the top of the storage support (A) and 1
of the slots (B) in the roller tube concurrently Note
the direction the curtain is wrapped and completely
remove the curtain from the roller tube while leaving
inserted in the storage post slot
3 Ensure the square latch bar is still engaged in the
latch bracket Pull the curtain evenly taut, towards the
roller tube until the curtain face is vertical
4 Determine the first available pocket that would
accommodate the round retainer bar Mark the
vertical set of desired pockets
5 Unlatch the square latch bar from the receiver post,
allowing slack to be pulled from the back of the
storage post
NOTE:
Do not remove curtain slot in the storage post
6 Place on a clean flat surface with access to the
desired pocket
7 Move the round retainer bar from its shipped position
into the pocket location determined in Step 4 Ensure the
retainer bar is positioned vertically through all 3 pockets
8 Secure the retainer bar at each pocket
using a tek
screw
9 Return the square latch bar to the latch bracket on
the receiver post
10 At the storage post (while observing the vertical
placement marked on the roller tube from Step 1 and
the wrap direction noted in Step 2) return the curtain
to the roller tube Fasten the end of the curtain to the
roller tube using the hook and loop fastener
11 Carefully remove the screwdriver holding the roller
tube and slowly releasing the spring energy
12 Cycle the curtain in and out at least 3 times to re-seat
the curtain on the roller tube
Figure 6
Rite‑Hite
®
Installation/Service/Owner's Manual
Dok‑Guardian™ LD Safety Barrier
Publication:
AMEN00150 2019-11-13
9
