RITE-HITE RHR-600 DOK-LOK Owner’s Manual
9
Welding Installation Instructions
If the installation being worked on is a “reinstallation” the
following electrical connections must be disconnected prior to
welding. Make sure to LOCKOUT/TAGOUT the power at the
fused disconnect, then, remove motor and limit switch
connections from the control harness located inside the motor
cover and disconnect the ground located in the outside junction
box. Once all welding procedures have been completed,
reconnect all wires.
NOTE 1
:
Figure 6
– Plug weld all holes that are in contact
with pit curb steel. All fifteen (15) holes must be
either plug welded or anchored.
NOTE 2
:
Figure 6
– Shims must be the full length of the
roller track mounting plate. Minimum electrode
must be 1/8” 7018 or better.
NOTE 3
:
Figure 6
– Never install
DOK-LOK
vehicle
restraint directly onto concrete block or brick dock
face.
NOTE 4
:
Figure 6
– When welding
DOK-LOK
vehicle
restraint, disconnect power and ground leads to
DOK-LOK
vehicle restraint and leveler.
NOTE 5
:
Figure 6
– Due to actual conditions, total mounting
height may be different. Refer to
RITE-HITE
Application Guidelines
for actual mounting height.
Special Application Installation
NOTE 1
:
Figure 9
– Shim as required behind track angles
(1/2" thick minimum bar stock) and weld in place.
Never weld on the RHR-600
DOK-LOK
vehicle
restraint after motor is wired into the control box and
the power to the box is on. Electrical current from the
welder can “feedback” through the circuit and
damage the motor and other components.
Figure 6
: Welding Roller Track, Front View
Add length to lip guide as required (supplied by
others). Weld in place as shown in
Figure 9
. Do not
weld to leveler front frame angle.
IMPORTANT
See NOTE 1
-
NOTE 5
.
See NOTE 5
IMPORTANT
Figure 7
: Welding Roller Track, Side View
Figure 8
: Roller Track, Front View
Figure 9
: Roller Track, Side View
See NOTE 1
.
Summary of Contents for DOK-LOK RHR-600
