Pub. No. 8000CLB FEBRUARY 2004
5
PROTECDOR® CL Model 8000CL
8.
Be sure that the wires and connectors coming out of each
end of the crossbeam and top of the sideframes are free
and clear before fastening the crossbeam,
Figure 5.
NOTE: Solid plastic or metal shims must fully support the
sideframe base plate. Drill through the shims to
allow for the proper installation of the anchor bolts
9.
Install the top seal crossbeam to the sideframe
assemblies and secure with two 3/8" x 1" bolts and flat
washers at each end,
Figure 5.
10.
Check the front edge of the sideframe assemblies for
squareness by referencing the chalkline,
Figure 6.
NOTE: Front edge of sideframe assembly must be flush or
within 1/8" inside of chalk line, if not install solid
plastic or metal shims behind the sideframe
assembly to align the sideframe with the chalk line.
11.
Using the predrilled holes in the sideframe assembly base
as a guide, drill the anchor holes for the floor bolts into
the concrete,
Figure 6.
If the installation requires the use
of shims, predrill the shims to allow for the anchor bolt.
Install the anchor bolts and fully tighten.
12.
Fully tighten all remaining anchor bolts or thru-bolts on
both sideframes. Check to see that the back of the
sideframe is flush with the wall,
Figure 7.
Make sure to
check that both the top of the sideframe and the top seal
crossbeam above the motor are flush with the wall. If a
gap on either side of the drive side sideframe of more
than 1/16" is noticed, insert metal shims to fill the gap
before tightening the thru-bolts. Make sure to position the
shims as close to the thru-bolts as possible. This is
important at the top of the drive side sideframe assembly
to make sure that the drive motor and pulleys are aligned.
NOTE: If this procedure is not followed, the sideframe
assembly could be twisted slightly, causing the
drive belt and limit switch belt to not track properly.
ROLLER TUBE ASSEMBLY / DRIVE BELT
NOTE: When overhead fork truck mast clearance is a
problem, additional support blocks will need to be
added under the roller tube assembly. Securely attach
wooden supports to the roller tube assembly and lift
into position as stated in normal installation procedures.
SIDEFRAME INSTALLATION INSTRUCTIONS
FIGURE 6
FIGURE 7
FIGURE 8
DO NOT remove the shipping bands from the roller
tube assembly before completing installation.
IMPORTANT!!!
Secure the roller tube assembly to the lift truck
forks before attempting to position the roller
tube assembly,
Figure 8
.
CAUTION !!!
!
