2 Auto-run
This Thermostat comes preprogrammed with an Energy-Star
TM
approved program. This program is recommended by the EPA for
energy efficiency.
We strongly recommend that you Auto-Run this
program for one week, and see if it works for you.
If it does not fit your needs you can always input a
custom program.
To Auto-Run the Energy-Star
TM
program, select HEAT or COOL with the mode
switch. The unit is now running the Energy-Star
TM
program.
The clock and the ambient temperature are displayed on the right.
They alternate every 2 seconds. One of the TIME SLOT icons P1/P2/P3/P4
comes on, this indicates the TIME SLOT active in the Energy-Star
Tm
program.
The programmed temperature is shown on the left. For program details refer to
the Energy-Star
TM
program chart below.
3 Program
Select HEAT with the HEAT/Cool MODE switch.
Select the day you want to program: Press the
PROGRAM to enter programming mode. The
PROGRAM FOR icon will come on. The day icon will
show SU (Sunday). Press
day
again to advance
the day selection.
Select the TIME SLOT you want to program: To change the TIME SLOT
(P1, P2, P3, P4) press the
NEXT
button. The display will cycle through the
time periods in sequence. Select P1.
Select the desired temperature for that TIME SLOT : To change the
temperature for that TIME SLOT press the TEMP UP / TEMP DOWN buttons.
Select the time of day you want that TIME SLOT to represent:
To set the time when P1 will begin , press the
<TIME
or
TIME>
buttons to
move the set point forward or backward in time.
NOTE: 60 Second Rule-During programming, if a button is not
pushed within 60 seconds, the unit will go out of the set mode.
Everything you have input in this programming will automatically be saved.
NEXT
P
DAY
PG
3
PG
4
All Days
70
o
F
62
o
F
70
o
F
P1
6:00am
HEAT
P2
8:00am
P3
6:00pm
P4
10:00pm
All Days
78
o
F
85
o
F
78
o
F
P1
6:00am
COOL
P2
8:00am
P3
6:00pm
P4
10:00pm
TIME
TIME
SET TEMP
SET TEMP
