Step 8:
Connect Loudmouth Power and Speaker Cables through
Strain Relief (Optional)
1. Route the Loudmouth power and speaker
cable connectors through the strain relief
clinching nut that was removed in Step 7.
L
o
u
d
M
o
u
t
h
L
o
u
d
M
o
u
t
h
Loop cables
Cable tie
Strain relief
Strain relief plug
Strain relief clinching nut
Power connector
Speaker connector
2. Route the Loudmouth power and speaker
cable connectors through the strain relief
installed on the LMH-100 enclosure.
3. Connect the power connector to the
Loudmouth DC power jack on the
Loudmouth case (left side jack), and the
speaker connector to the phono jack on the
Loudmouth case (right side jack).
4. Insert through the strain relief enough length
of both cables to create a loop as shown at
right.
5. Use a plastic cable tie (02800088) to secure
both cables to the LMH-100 mounting plate
(25110100). Thread the cable tie through
the hole in the mounting plate and tightly
secure both cables.
6. Press the rubber strain relief plug
(25204700) into the strain relief installed on
the LMH-100 enclosure, between the
speaker and power cables. The plug should
be fully inserted into the strain relief.
7. Tighten the strain relief clinching nut onto the
strain relief to compress the plug and seal
the cables.
Publication No. 14520009
LMH-100 Installation Instructions
Page 4
