Rittal 7857.430, Assembly And Operation Instructions Manual

UPS Functional Descriptions  

UPS-Manual 

9

EN 

3.4.  Operating Modes & UPS 

Configuration 

Install the “Rittal PMC12 UPS-Software“ from 
the enclosed CD or download it from 

http://www.rimatrix5.com/service_support/downloads.asp

.

Run the programm „UPSMan Configuration“. 
The following Window appears: 

3.4.1. System Configuration 

 
1.  Select the UPS-type and the number of 

battery packs you have connected. The data 
in the lower part of the window will be filled in 
automatically..  

2.  Name the location of the UPS 
3.  Choose the port on which the UPS is 

connected to your PC. (If you choose 
„CS122“, you have to write down the IP-
address of the UPS-System). 

4.  If you did not write down a valid licence key 

during the installation you have the 
possibility to switch your 30-days trial 
version into a full-version later, by tipping in 
a valid key. 

5.  The button „Advanced User“ allows you to 

edit the before locked fields of the window. 
This function should only be used by 
persons who have detailed knowledge 
about the UPS-System. Rittal takes no 
responsibility for system failure which is 
caused by false data. 

6.  To save the settings press “OK”. To activate 

the configuration you have to restart the UPS-
System. 

3.4.2.  Using the Software 

1.  Run the program „UPSMonitor“ 
2.  Choose the connection on which the UPS 

is connected to the PC. 

3.  After the connection was successful the 

main menu of the program will open. There 
you have an overview about all parameters 
of the UPS. The configuration of the UPS 
is finished. 

3.4.3.  Configuration of the 

programmable outlets 

The UPS has 2 programmable outlets on which 
uncritical loads can be connected. These 
outlets can be switched off and offer therefor a 
longer power supply to even more critical loads 
in case of a power fail or overload of the UPS.  
 

Click in the upper side of the window on the 
button “Functions" 

Æ

 „Device Functions“ and 

then click in „Extended Cmds“. 

Here you can manually switch the two outlets 
and initiate a restart or switch off the UPS. 

The button „Programmable Outlet Settings“ 
allows you to program the outlets.