10.2
Homepage
Fig. 79: Maintenance program homepage
The following options are shown after starting the maintenance program:
● Project (Fig. 79/1)
Chapter 10.3 “Project” on page 94
– Read data (Fig. 79/2) (gray background, if no system is connected)
– Transfer data (Fig. 79/3) (gray background, if no data has been imported yet)
– New project (Fig. 79/4)
– Open project (Fig. 79/5)
– Save project (Fig. 79/6) (gray background, if no project was opened previ-
ously)
Chapter 10.4 “Event memory” on page 94
● Firmware (Fig. 79/13)
Chapter 10.5 “Firmware” on page 94
Chapter 10.6 “Customer data” on page 95
Chapter 10.7 “Operation” on page 97
The following information is displayed:
● Network Interface Card serial number, Network Interface Card version number
● Firmware version (Fig. 79/9)
The following input option exists:
● The project can be described in the project description (Fig. 79/10).
This description is saved with the project via "Save project as" or via "Save
project" with the data on the
PC
. The project description is not transferred to the
system (DET-AC III Master) and it is not saved in the system. The project
description is not available after the data has been exported from a system.
Maintenance program
Operating Instructions / DET-AC III Master / 916005 / 11-2022 / en_US
93
