Documentation Notes 2
4
Switched Power Distribution Unit
EN
2
Documentation Notes
The audience for this guide is the technical spe-
cialist familiar with the assembly, installation and
operation of the Switched PDU System.
You should read this operating guide prior to
commissioning and store the guide so it is readily
accessible for subsequent use.
Rittal cannot accept any liability for damage and
operational malfunctions that result from the non-
observance of this guide.
Retention of Documents
This guide and all associated documents are part
of the product. They must be given to the operator
of the unit and must be stored so they are avail-
able when needed.
Symbols Used
The following safety and other notes are used in
this guide:
Symbol for handling instructions:
•
This bullet point indicates that you should
perform an action.
Safety and other notes:
Danger!
Immediate danger to health and life!
Warning!
Possible danger for the product and
the environment!
Note!
Useful information and special features.
3
Safety Instructions
1. Assembly and installation of the Switched
PDU, in particular for wiring the enclosures
with mains power, may be performed only
by a trained electrician. Other tasks asso-
ciated with the PDU, such as the assembly
and installation of system components with
tested standard connectors, and the opera-
tion and configuration of the PDU may be
performed only by instructed personnel.
2. Do not open the case, as there are no ser-
viceable parts inside. Your warranty will be
void.
3. Do not try to repair the unit yourself; contact
your local supplier or your warranty will be
void.
4. If liquids are spilt onto the PDU or foreign
objects dropped into the unit, the warranty
will be null and void.
5. Do not install the PDU in an environment
with sparks, smoke or gas.
6. The PDU is designed to be installed and
commissioned in a sheltered, controlled en-
vironment as follows:
-
Operating temperature 0-40°C and 5-
90% non-condensing humidity.
-
Always avoid contact with direct
sunlight.
-
Do not install the PDU in inflammable
or hazardous environment.
-
Dusty,
corrosive
and
salty
envi-
ronments can do damage to the PDU.
-
Install the PDU indoors as it is not de-
signed for installation outdoors.
7. Install the PDU away from objects that give
off excessive heat and areas that are ex-
cessively wet.
8. Always switch off the PDU when relocating
it.
9. Make sure that the AC main supply outlet is
correctly grounded.
10. Please ensure that the input voltage of the
PDU matches the utility supply voltage.
11. Observe the valid regulations for the elec-
trical installation for the country in which the
unit is installed and operated, and the na-
tional regulations for accident prevention.
Also observe any company-internal regula-
tions (work, operating and safety regula-
tions).
Use only genuine or recommended parts and
accessories. The use of other parts can void the
liability for any resulting consequences.
