9 Machine decommissioning and disposal
26
We reserve the right to make technical modifications.
Rittal electrical crimping machine R8 E
EN
Display on touch
display
Cause
Correction
Drum position incorrect or
does not match the insula-
tion stripping stage.
The drum must be at the correct
position.
–
Jogging operation
Setting error
–
The insulation stripping
stage and the die size do
not match.
◼
Press the touch display once
briefly.
Machine not at the initial
position.
◼
Travel in jogging operation to
initial position.
Note:
If there are further faults, contact the manufacturer.
8.5
Removing the wire end ferrule
◼
Open the front flap (see fig. 1, item 3).
◼
Search for missing wire end ferrule.
◼
If required, remove the transport unit (see section 7.6
).
◼
Remove the wire end ferrule.
◼
If required, reinstall the transport unit.
◼
Close the front flap.
◼
Tap the touch display briefly.
9
Machine decommissioning and disposal
9.1
Machine decommissioning
◼
Switch off the machine.
◼
Withdraw the mains plug.
◼
Pack the machine in the original packaging.
The machine is now prepared for transport and disposal, if necessary.
9.2
Machine disposal
◼
Decommission the machine as described in section 9.1 "Machine decommission-
ing".
◼
Ensure the machine disposal in accordance with the national and local regula-
tions.
Machine disposal as house refuse is not permitted.
The machine should be disposed of environmentally conform and
properly.
Note:
You can send the product to Rittal for disposal. Contact your re-
sponsible country representative.
