2 General safety instructions
Ritta l electrical crimping machine R8 E
We reserve the right to make technical m odifications.
7
EN
personnel. Only for
switched-off state of the
machine. After removal of
the housing, ensure that
the earthing wire is insert-
ed before the machine is
closed again.
Safety switch
The safety switch is acti-
vated when the front flap is
opened.
By a qualified electrician.
LPV-100-24 switched-mode
power supply (SMPS)
The SMPS protects against
dangerous voltages, be-
cause not more than 60
VAC or 110 VDC may be
present.
By a qualified electrician.
2.7
Warning signs at and on the machine or components
–
PE conductor connection: This marking is placed on the earth screw.
Symbol
Meaning
The protective earth is a measure that in the event of a fault protects
against dangerous touch voltage and electrical shock. The "protective
earth" measure is provided by the protective conductor.
The connection is made via an IEC connector with leading protective conductor
contact. The "PE" protective conductor (green/yellow insulating sheath only in
Germany) is used for these protective measures.
2.8
Residual risks
Even when all safety and warning notes are observed, residual risks remain for the
machine operation.
The machine is state-of-the-art and built according to recognised safety regula-
tions. Nevertheless, hazards for users or third-parties can result when operating
the machine.
–
The machine may be used only for the intended purpose.
–
The machine must be in proper safety condition during commissioning.
–
Faults that can impair the safety must be rectified immediately, whereby the
manufacturer may need to be contacted.
–
For opened flap, access to the fixed blade is possible and so cut injuries can re-
sult.
–
Manipulation of the safety devices can cause the reoccurrence of the described
hazards.
2.9
Safety measures at the installation site
The machine must be placed stable on a table.
–
There is a large hazard risk should a machine fall.
Note:
Inner-company instructions and checks should ensure that the work-
place and its vicinity remain clean and uncluttered.
2.10
Notes for the operating company
–
The operating company is obliged to write operating instructions.
–
The operating company is obliged to inspect the safety devices annually.
