HD Series
RC2103HD-6511 Installation Guide
01-2015-A
www.rivatech.de
8
1)
Place the installation template included
in the package on the desired installation
surface.
2)
Drill holes on the correct spots based on
the template paper, and insert the anchor
blocks into the holes.
3)
Open the dome cover.
*Refer to the caution below for the details of
how to open the cover.
4)
Connect necessary cables including a
LAN cable and a power cable to the
camera.
5)
Hold the camera against the surface
where the camera will be mounted by
matching the alignment holes with the
corresponding anchor blocks.
6)
Route the cables through the cable hole
at the bottom of the camera, and tighten
the anchor blocks with the screws.
7)
Attach the dome cover on the main
body, and lock it up by rotating the dome
cover.
*Refer to the caution below for the details of
how to attach the dome cover.
Caution
!
When placing the dome cover, look for the carved triangle mark on both dome
cover and main body. Both triangles should be aligned together when placing the
cover. Once the cover has been placed, rotate the dome cover clockwise for a
secure lock. To detach the cover, rotate the cover counterclockwise. Then, align
the two triangle marks each other, and pull the cover.
Caution
!
To prevent products from damage, place the camera on a stable and
non-vibrating surface. If the stability is in doubt, consult safety personnel for
reinforcements, and then proceed with the installation.