1. Unplug the unit and allow to cool.
2. Do not use steel wool or other abrasive cleaners not recommended for
non-stick surfaces.
3. Clean outside of unit and grids with a damp cloth moistened in mild
soapy water.
4. Wash the cone roller with mild soapy water.
CAUTION: Do not immerse unit in water or other liquid.
-5-
CARE AND CLEANING OF YOUR WAFFLE CONE MAKER
-4-
HOW TO USE YOUR WAFFLE CONE MAKER
1. Plug cord into 120 volt AC outlet with the lid of the unit closed. The
Indicator light will turn on.
2. Let the unit heat until the Indicator light turns off.
CAUTION: Always use hot mitts that extend past the wrist and keep
exposed skin away from unit as escaping steam and hot surfaces may
cause burns.
3. Open lid and drop
1/4
cup of batter onto the center of bottom grid.
4. Promptly close lid and hold down firmly for 20 seconds.
5. After 20-30 seconds, lift the lid to check the color. If it is too light, close
lid and bake for another 10 seconds. Roll as directed on page 6.
NOTE: Waffles are done when steam stops escaping from unit
(approximately 30-40 seconds). Do not lift lid while waffles are steaming.
This may cause them to stick or separate.
CAUTION: Always unplug your Waffle Cone Maker immediately after
use. Never leave unattended.
BEFORE YOU USE YOUR WAFFLE CONE MAKER
1. Before using your Rival Waffle Cone Maker for the first time, wash grids
with a damp cloth moistened with mild soapy water. Rinse well and dry.
2. To maintain the non-stick surface, lightly oil the grid surface before
heating.
NOTE: Use only wooden, plastic, or rubber utensils. Metal or sharp
utensils will damage the surface. A light smoke vapor may occur the
first time your Waffle Cone Maker is plugged in. This is normal for a
new appliance.
WC800.01.US.OMI 12/19/01 8:48 AM Page 4
