28 | Replacing SteelConnect SDI-2030 and SDI-5030 Gateway Components
Replacing disk drives
2. Align the air duct over the fans and lower the air duct into place to reinstall the air duct.
Figure 3-6. Installing the air duct
Replacing disk drives
This section describes how to remove and replace the disk drives.
Note:
If you need to replace a gateway, you cannot move the disks to preserve your data. Each disk is encoded with
machine-level information and moving disks is not supported.
The SDI-2030 and SDI-5030 gateways are equipped with replaceable, hot-swappable, 3.5-inch hard-
disk drives (HDD). When replacing a drive, replace only one drive at a time. You must use approved disk
drives. To order disk drives, contact Riverbed Support at https://support.riverbed.com.
Note:
When you replace disk drives, you must wear a grounded ESD antistatic strap to protect the hardware against
electrostatic discharge. Make sure that the strap makes skin contact prior to handling equipment.
Caution:
Use caution you remove or replace gateway components; they can become hot to the touch.
To replace a disk drive
1. Remove the bezel.
See
“Removing and installing the bezel” on page 25
2. Identify the faulty disk drive. See
for disk drive numbering.
Figure 3-7. Disk drive numbers
