XH2-240 Hardened Access Points
2
only 802.3at (POE+) compatible switches or power injectors, or a Riverbed-supplied PoE
injector (the 30W XP1-MSI-30, or current models rated at 70W or higher).
(Optional)
GIGABIT2
—Connection to this second, data-only Gigabit port provides
additional bandwidth. Use Cat 5E or Cat 6 cable.
The AP protects its inputs from typical static charge buildup on antennas. In areas where
lightning surges are a concern, a lightning arrestor may be used between the antenna and
the AP, with 6 AWG copper wire from the arrestor to a good earth ground.
NOTE: PoE Injectors and switches must be installed and used indoors.
NOTE: If XH2 models are used indoors, they are to be connected only to PoE networks
without routing to the outside plant.
NOTE: The AP comes with plastic covers installed on Ethernet and antenna ports. You
MUST leave these covers securely installed on unused ports to prevent weather damage.
Choose a Suitable Location
The XH2-240 is tested to IP67 waterproof and dust-proof requirements to protect against
severely wet and dusty environments. For optimal placement, we recommend that a predictive
survey be performed by a qualified Riverbed partner.
Choose a location that is not subjected to submersion.
Direct sunlight may raise the effective ambient temperature many degrees above air
temperature. It is best to choose a location that has some protection from the sun.
The maximum cable length between the XH2-240 and the RJ-45 Ethernet network is 100
meters. A PoE injector is not a repeater, so its location will not increase this distance.
The XH2-240 can operate from a Wireless Distribution System (WDS) link. However, the
unit will need to be configured via the Ethernet connection prior to mounting and power
must still be supplied via the GIG1 Ethernet connector.
Keep the unit away from electrical devices or appliances that generate RF noise—at least 3
to 6 feet (1 to 2 meters).
The AP must be installed in a position so that the LED’s cover is not directly affected by the
Sun's radiation (typically with the LED and Ethernet connectors facing down).
2
