STEP 5
1.
Attach magnet (J) to bottom of top board (7) by inserting 2 wood screws through holes on magnet (J) and
tighten to top board (7).
2.
Screw 4 cam bolts (small-B) into pre-threaded holes on top board (7).
3.
Insert 4 wood dowels (A) into dowel holes on top board (7).
4.
Attach top board (7) to upper left side panel (4) and upper right side panel (3) by inserting wood dowels (A)
into dowel holes and cam bolts (small-B) into cam lock holes on upper left side panel (4) and upper right
side panel (3).
5.
Insert 4 cam locks (small-C) into cam lock holes on upper left side panel (4) and upper right side panel (3),
and rotate clockwise to secure cam bolts (small-B) in place.
STEP 6
1.
Screw 6 cam bolts (large-D) into pre-threaded holes on lower left side panel (17) and lower right side panel (18).
2.
Insert 6 wood dowels (A) into dowel holes on lower left side panel (17) and lower right side panel (18).
3.
Attach 2 lower section top cross bars (15) to lower left side panel (17) and lower right side panel (18) by
inserting wood dowels (A) into dowel holes and cam bolts (large-D) into cam lock holes.
4.
Insert 4 cam locks (large-E) into cam lock holes on lower section top cross bars (15) and rotate
clockwise to secure cam bolts (large-D) in place.
5.
Attach rear lower cross bar (16) to lower left side panel (17) and lower right side panel (18) by inserting wood
dowels (A) into the dowels holes and cam bolts (large-D) into cam lock holes.
6.
Insert 2 cam locks (large-E) into cam lock holes on lower section top cross bars (16) and rotate
clockwise to secure cam bolt (large-D) in place.
