Check for parts online at
www.HuntRiversEdge.com
or call 800-345-6007 M-F 8-5
7
Operator's Manual
BOWMAN XT Ladder Stand
ASSEMBLY INSTRUCTIONS
IMPORTANT ASSEMBLY TIP:
Do not tighten any nut and bolt combinations completely
until all parts are assembled together! Finger tighten plus one
turn of a wrench only! This will temporarily hold the lock nut
on the bolt while helping alignment of all parts! After all parts
are assembled together, all nut & bolt combinations must be
completely tightened.
All assembly must be done in this order at ground
level before uprighting.
Do not remove labels/warnings from product, they
are there for your safety.
Recommended for adult use only.
FIGURE
1
FIGURE
2
2. Attach the front of seat side rails (11) to the flared
platform rails (5) using two 1/4-20 x 1-1/2 IN bolts (23) and
locknuts (26). SEE FIGURE 2.
3. Attach tree blade (14) to the rear of seat side rails (11)
using four 1/4-20 X 2-1/4 IN bolts (24) and locknuts (26).
SEE FIGURE 2.
NOTE: When selecting a tree to install the treestand
in, never use a treestand on a dead, leaning,
diseased or loose barked tree, or a utility pole.
Always avoid electrical power lines.
1. Attach two flared platform rails (5) to platform (4) using
two 1/4-20 X 2-1/4 IN bolts (24), yellow washers (18) and
locknuts (26). SEE FIGURE 1.
26
4
5
18
24
5
23
26
Mesh hidden for clarity
11
14
26
24
Summary of Contents for BOWMAN XT
Page 6: ......
