Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
10
Operator's Manual
Rivers Edge® One-Man Ladder Stands
ASSEMBLY INSTRUCTIONS (RE627)
Tools needed – two 7/16” wrenches, one 9/16" wrench
IMPORTANT ASSEMBLY TIP: Do not tighten any nut and bolt combinations
completely until all parts are assembled together! Finger tighten plus one
turn of a wrench only! This will temporarily hold the lock nut on the bolt while
helping alignment of all parts! After all parts are assembled together, all nut
& bolt combinations must be completely tightened.
1. Attach the front platform (410050) and the rear platform (410058)
together using (2) provided 1/4-20 x 2” bolts, locknuts and steel
washers.
SEE FIGURE 1.
DO NOT tighten all nut and bolt assem-
blies completely!
NOTE: Mesh surface of foot platforms should be on top.
2. Attach the platform support rails (410055) to the bottom of as-
sembled foot platforms using (8) provided 1/4-20 x 2-1/4” bolts,
locknuts and steel washers.
SEE FIGURE 2.
3. Attach the platform flat support braces (1ML40) to the rear plat-
form and platform support rails using (4) provided 1/4-20 x 1-1/2”
bolts and locknuts.
SEE FIGURE 2.
Figure 1
Figure 2
front platform
rear platform
1/4-20 x 2" bolt
steel washers
locknuts
rear platform
platform support rail
flat support
braces
1/4-20 x 2-1/4" bolts
steel
washers
locknuts
1/4-20 x
1-1/2" bolts
