Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
14
Operator's Manual
Rivers Edge® One-Man Ladder Stands
Figure 15
Figure 16
Figure 17
shooting
rail J-pipes
shooting rail
1/4-20 x 1-1/4" bolt
1/4-20 x
2-1/4" bolts
bolt-on
ladder step
flared rails
seat assembly
1/4-20 x 2-1/4" bolts
nylon washers
locknuts
1/4-20 x
1-1/2" bolts
steel washers
locknuts
Figure 18
mesh backrest
retaining bar
1/4-20 x 1-1/2"
bolts
backrest spacer
locknuts
plastic stiffening
rods
3/8-16 nut
3/8" lock washer
9. Remove the locknuts from the (2) 1/4-20 x 2-1/4” bolts that were previ-
ously attached to the rear of the seat assembly. Continue by attaching
the seat assembly to the ladder side rails using (2) provided 1/4-20 x
2-1/4” bolts, locknuts and nylon washers.
SEE FIGURE 15. Make sure
all (4) angle brackets are fully cradling fabric rails.
NOTE: Mesh seat is not depicted in drawing so hardware can be visible.
10. Insert the shooting rail J-pipes (410113) into the shooting rail front
(410065) and secure together using (2) provided 1/4-20 x 1-1/4”
bolts and locknuts.
SEE FIGURE 16.
11. Insert the two side rails into the flared rails (410054). Secure using
(2) provided 1/4-20 x 1-1/2” bolts, locknuts and steel washers.
SEE
FIGURE 17.
12. Attach the bolt-on ladder step (410034) to the front side of flared
rails using (2) provided 1/4-20 x 2-1/4” bolts, locknuts and steel
washers.
SEE FIGURE 17.
13. Attach the mesh backrest assembly (360021) and the (2) retaining
bars (410081) to the backrest mounts using (6) provided 1/4-20 x
1-1/2” bolts and locknuts.
SEE FIGURE 18.
The mesh backrest must
wrap around the front side of backrest mounts and the plastic stiff-
ening rod located in the sewn sleeve on each side of the backrest
MUST be positioned behind the backrest retainer bars to act as a
stop and prevent the backrest from pulling out during use. All bolts
MUST go through the backrest retainer bars, the holes provided in
the backrest and the backrest mounts.
SEE FIGURE 18.
Temporary
removal of the backrest mount tube from the rest of the assembled
ladder top may be necessary to attach the mesh backrest. If this is
needed, re-attach backrest mount tubes with mesh backrest to the
ladder top assembly.
