Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
24
Operator's Manual
Rivers Edge® One-Man Ladder Stands
9. Remove the locknuts from the (2) 1/4-20 x 2-1/4” bolts that were previ-
ously attached to the rear of the seat assembly. Continue by attaching
the seat assembly to the ladder side rails using (2) provided 1/4-20 x
2-1/4” bolts, locknuts and nylon washers.
SEE FIGURE 15. Make sure
all (4) angle brackets are fully cradling fabric rails.
10. Insert the shooting rail J-pipes (410113) into the shooting rail front
(410093) and secure together using (2) provided 1/4-20 x 1-1/4”
bolts and locknuts.
SEE FIGURE 16.
11. Insert the two side rails into the flared rails (410089). Secure using
(2) provided 1/4-20 x 1-1/2” bolts, locknuts and steel washers.
SEE
FIGURE 17.
12. Attach the bolt-on ladder step (410034) to the front side of flared
rails using (2) provided 1/4-20 x 2-1/4” bolts, locknuts and steel
washers.
SEE FIGURE 17.
13. Attach the mesh backrest (360022) and the (2) retaining bars (410081)
to the backrest mounts using (6) provided 1/4-20 x 1-1/2” bolts and
locknuts.
SEE FIGURE 18.
The mesh backrest must wrap around the
front side of backrest mounts and the plastic stiffening rod located
in the sewn sleeve on each side of the backrest MUST be positioned
behind the backrest retainer bars to act as a stop and prevent the
backrest from pulling out during use. All bolts MUST go through
the backrest retainer bars, the holes provided in the backrest and
the backrest mounts.
SEE FIGURE 18.
Temporary removal of the
backrest mount tube from the rest of the assembled ladder top may
be necessary to attach the mesh backrest. If this is needed, re-attach
backrest mount tubes with mesh backrest to the ladder top assembly.
14. Thread the non-locking 3/8-16 nut onto the threaded end of spacer
rod all the way to the bottom of threads and slide 3/8” lock washer
on. Insert the threaded end of spacer rod through either backrest
mount tube far enough to be able to insert the opposite end of
spacer rod (end with welded-on washer) into opposite backrest
mount tube. Thread 3/8-16 nut back against mount tube. Using a
9/16” wrench, tighten nut until mesh backrest becomes taut.
SEE
FIGURE 18. You must now tighten all nut and bolt assemblies.
Be sure not to over tighten or crush tubing when tightening!
Figure 15
seat assembly
1/4-20 x 2-1/4" bolts
Figure 16
Figure 17
Figure 18
1/4-20 x
2-1/4" bolt
bolt-on
ladder step
flared rails
mesh backrest
retaining bars
1/4-20 x 1-1/2" bolts
backrest spacer
locknuts
nylon washers
steel washers
locknuts
locknuts
1/4-20 x 1-1/4"
bolts
shooting rail J-pipes
shooting rail
1/4-20 x 1-1/2"
bolts
locknuts
plastic stiffening
rods
3/8-16 nut
3/8" lock washer
