Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
31
Operator's Manual
Rivers Edge® One-Man Ladder Stands
5. Attach the round tube, double flat braces (10377) to the upper lad-
der support tubes using (4) provided 1/4-20 x 1-1/2” bolts and lock-
nuts.
SEE FIGURE 4.
One double flat brace should be positioned on
each side of the upper ladder support tubes for clearance purposes.
6. Attach the bolt-on step (410034) to the front side of flared rails us-
ing (2) provided 1/4-20 x 2-1/4” bolts, locknuts and steel washers.
SEE FIGURE 4.
7. Attach the shooting rail posts (10393) to the main side rails using
(4) provided 1/4-20 x 1-3/4” bolts and locknuts.
SEE FIGURE 5.
8. Insert the shooting rail J-pipes (410113) into the shooting rail rim
(10394). Secure together using (2) provided 1/4-20 x 1-1/2” bolts,
locknuts and steel washers.
SEE FIGURE 6.
You must now tighten
all nut and bolt assemblies.
Be sure not to over tighten or crush
tubing when tightening!
9. Attach the factory assembled mesh seat with seat rails (10549) to
the previously assembled upper ladder stand assembly.
a. Using (2) provided 1/4-20 x 2-1/2” bolts, locknuts and steel washers,
attach the upper portion of each seat rail to the main side rails.
SEE FIGURE 7.
It is important to have the bolt head on the seat rail
side and the locknut on the main side rail side for ease of assembly.
FINGER TIGHTEN THESE TWO BOLTS ONLY AT THIS TIME.
b. Using (2) provided 1/4-20 x 2-1/4” bolts, locknuts and steel
washers, attach the lower portion of each seat rail to the upper
ladder support tubes.
SEE FIGURE 7
. It is important to have the
bolt head on the seat rail side and the locknut on the upper
ladder support tube side for ease of assembly.
c. Alternately tighten all four nut/bolt assemblies from steps 9a
and 9b. The spanned mesh seat will become tighter as you tighten
each nut/bolt assembly. Tighten until all steel tubular components
are tight to each other, locking feature of nuts are fully engaged
by bolt threads and spanned mesh seat is taut.
Be sure not to
over tighten or crush tubing when tightening!
Figure 4
Figure 5
Figure 6
Figure 7
1/4-20 x 1-1/2"
bolts
1/4-20 x 2-1/4"
bolts
locknuts
1/4-20 x 1-1/2"
bolts
locknuts
locknuts
steel washers
locknuts
1/4-20 x 1-3/4"
bolts
shooting rail posts
1/4-20 x 1-1/2" bolts
locknuts
shooting rail J -pipes
shooting rail rim
steel washer
locknuts
1/4-20 x 2-1/2" bolts
steel washers
seat rails
1/4-20 x 2-1/4" bolts
steel washers
locknuts
bolt-on step
double flat braces
