Operators Manual
Rivers Edge® Perimeter™ Pod Curtain Kit
Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
5
ASSEMBLY INSTRUCTIONS
Tools needed – two 7/16” wrenches
IMPORTANT ASSEMBLY TIP:
DO NOT TIGHTEN NUT & BOLT COMBINATIONS
COMPLETELY UNTIL ALL PARTS ARE ASSEMBLED
TOGETHER! FINGER TIGHTEN ONLY PLUS
ONE TURN OF A WRENCH ONLY! THIS WILL
TEMPORARILY HOLD THE LOCK NUT ON THE BOLT
WHILE HELPING ALIGNMENT OF ALL PARTS! AFTER
ALL PARTS ARE ASSEMBLED TOGETHER, ALL NUT
& BOLT COMBINATIONS MUST BE COMPLETELY
TIGHTENED!
1. Attach the (4) uprights (TP162) to the platform using
(4) provided 1/4-20 x 2” bolts, locknuts and washers.
SEE FIGURE 1.
DO NOT tighten all nuts and bolts
completely!
2. Attach the (4) flat bar supports (AL7) to the inside of
uprights using (4) provided 1/4-20 x 1-1/4” bolts and
locknuts.
3. Attach the opposite end of flat bars supports to the
platform using (4) provided 1/4-20 x 1-1/2” bolts and
locknuts.
4. Insert the (2) curtain rails (TP161) into the (2) spanner
tubes (TWR26) forming a square. Using (4) provided 1/4-
20 x 1-1/4” bolts, locknuts and washers, secure the curtain
rails and spanner tubes together.
5. Attach the assembled rail square to the outside of
uprights using (4) provided 1/4-20 x 2” bolts, locknuts and
washers.
You must now tighten all nut & bolt assemblies
securely. DO NOT crush tubing when tightening!
6. The side of curtain with numerous Velcro loops is the
top side of curtain. Attach the top side of curtain to the
curtain frame by wrapping all Velcro attachment points
around metal tubing and securing together. Curtain
should be positioned with zippered door on the front/
center of your ladder for entry and exit purposes.
7. Once top of curtain is secured properly, pull the bottom
edges of curtain down around the foot platform. The
sewn-in elastic bungee will securely grab the lower
corners of your platform. Attach remaining Velcro loops
on bottom/back seam of curtain securely.
SPANNER TUBE
POD
CURTAIN
RAIL
1/4-20 x 1 1/2
BOLT
1/4-20 x 2
BOLT
1/4-20 x 1 1/4
BOLT
1/4-20 x 2
BOLT
WASHER
LOCKNUT
1/4-20 x 1 1/4
BOLT
FIGURE 1
