Check for parts online at
www.huntriversedge.com
or call 800-450-EDGE (3343) M-F 8-5
Check for parts online at
www.huntriversedge.com
or call 800-450-EDGE (3343) M-F 8-5
32
Operator's Manual
Rivers Edge One-Man Ladder Stands
17. Attach (2) door weldments (410017) to the door mount weld-
ments by inserting welded rod and square tube of door frame
into the locking position on the upper door mount frame plates.
Attach the lower portion of each door to the lower door mount
plate using (2) provided 1/4-20 x 1-3/4” bolts and locknuts. SEE
fIGuRE 11. Tighten nut only so that the bolt protrudes
through nyloc nut so that it is flush.
Test by lifting each door out of the lock position and making sure
the pivoting rod at the top of each door does not come out of the
upper door mount plates. Test the locking feature of each
door by dropping each door into the upper door mount plates
allowing the square tube portion of each door to securely lock.
notE: Make sure both doors are functioning properly at all
times. doors should pivot freely to and from the lock position.
nuts should be adjusted on bottom of doors to allow free travel,
but not allow the door pin at top to pull out of upper door
mount plates.
18. You must now tighten all remaining nut & bolt assemblies. Be
sure not to over tighten or crush tubing when tightening!
19. Sections are assembled on the ground in the following order;
bottom section (410025 3-step ladder); second section (410027
3-step ladder with stabilizer bar mount); third section (410028
3-step ladder w/ mounting holes); top section (assembled top
platform section). SEE fINIShED 15’ OPENING DAY lADDER.
20. With all sections assembled together on ground, secure all sec-
tions together using (6) provided spring lock pins. Handle of
spring lock pin must be put to the outside of ladder side rails.
SEE fIGuRE 12.
Figure 12
Figure 11
1/4-20 x 1-3/4”
bolts
locknuts
spring lock pins
door mount
weldment
welded rod and
square tube
door weldments
