Check for parts online at www.HuntRiversEdge.com or call 800-345-6007
15
Operator's Manual
JUMBO JACK 1-MAN Ladder Stand
SET UP AND USE INSTRUCTIONS
During installation and removal of ladder treestands,
you must always and properly use the included Full Body
Harness (Fall Arrest System). Refer to the Full Body Harness
instructions included with this product for proper use.
A
A
C
B
FIGURE 13
1. Select a straight, healthy tree. Do Not attempt to install on a tree
that is not healthy.
2. With assembled product lying on the ground, position one person
at bottom end of ladder lying on the ground. This person has to
prevent the ladder end from tilting up when platform end is lifted
and prevent the ladder from skidding across ground.
3. a. Position two people at the platform end of the ladder, lift the
platform end and continue uprighting by walking toward bottom
end of ladder and moving hands along ladder legs. Stand ladder
up against chosen straight tree on dry, level ground. Use
caution when ladder comes over center against the tree. SEE
FIGURE 13(A).
b. Step back and look at the ladder top to see that it is level. Adjust
as needed to achieve a level platform top. Make sure tree blade is
contacting tree. SEE FIGURE 13(B).
c. Step down hard on bottom step to push ladder legs into the
ground. SEE FIGURE 13(C).
4. While two people hold the stand in place, the third person should
connect the horizontal stabilizer bar to the tree. Adjust the length
of the stabilizer bar as need so it contacts the tree and is level to
the ground. Then secure it to the tree with the 6' cam strap (44) by
forming a cinch knot with both ends of the strap and running the
long end of the strap through the cam buckle. SEE FIGURES 14
AND 15.
FIGURE 14
FIGURE 15
B
A
C
D
E
FIGURE 16
WARNING
Never use a treestand on a dead, leaning, diseased or
loose barked tree, or a utility pole. Always avoid electrical
power lines.
Bring ratchet strap(s) up with you in a pocket - Do Not
carry in your hands!