Check for parts online at www.HuntRiversEdge.com or call 800-345-6007
8
Operator's Manual
JUMBO JACK 1-MAN Ladder Stand
ASSEMBLY INSTRUCTIONS
IMPORTANT ASSEMBLY TIP:
Do not tighten any nut and bolt combinations completely
until all parts are assembled together! Finger tighten plus
one turn of a wrench only! This will temporarily hold the
lock- nut on the bolt while helping alignment of all parts!
After all parts are assembled together, all nut and bolt
combinations must be completely tightened.
All assembly must be done in this order at ground
level before uprighting.
Do not remove labels/warnings from product, they are
there for your safety.
Recommended for adult use only.
STEP
1
STEP 2
NOTE: When selecting a tree to install the treestand in, never
use a treestand on a dead leaning, diseased or loose barked
tree, or a utility pole. Always avoid electrical power lines.
1. Attach seat side rails (15) to tree blade (22) using four 1/4-20 x
2-1/4 IN bolts (26) and nuts (30).
Insert flared platform rails (10) into the seat side rails (15) and
secure using two 1/4-20 x 1-1/2 IN bolts (25) and nuts (30).
2. Attach the left and right armrests (4 and 5) to the seat side rails
(15) through only the front hole using a 1/4-20 x 2-1/4 IN bolt (26),
a yellow washer (34) and nut (30) for each armrest.
Insert the right rear seat support (19) into the left rear seat
support (18). Then attach to the inside of the seat side rails (15)
while also attaching the back of left and right armrests (4 and 5)
to the outside of the seat side rails (15) using two 1/4-20 x 3 IN
bolts (28), two yellow washers (34), and nuts (30).
Attach the bolt on step (9) to the flared platform rails (10) using
two 1/4-20 x 2-1/4 IN bolts (26), two 1/4 IN steel washers (29) and
nuts (30).
Insert the M6 x 60 MM carriage bolts (32) into the square holes in
the armrests before moving on to the next step.
26
30
22
15
30
10
25
5
32
19
18
26
30
34
30
4
34
28
15
10
9
30
29
26
32
