Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
5
Operator's Manual
CLASSIC XT 1-Man Ladder Stand
IMPORTANT ASSEMBLY TIP:
Do not tighten any nut and bolt combinations completely until all
parts are assembled together! Finger tighten plus one turn of a wrench
only! This will temporarily hold the lock- nut on the bolt while helping
alignment of all parts! After all parts are assembled together, all nut
and bolt combinations must be completely tightened.
ASSEMBLY INSTRUCTIONS
All assembly must be done in this order at ground level before
uprighting.
Do not remove labels/warnings from product, they are there
for your safety.
Recommended for adult use only.
FIGURE
1
FIGURE
2
NOTE: When selecting a tree to install the treestand in, never use
a treestand on a dead, leaning, diseased or loose barked tree, or
a utility pole. Always avoid electrical power lines.
1. Slide the seat assembly (11) over the two seat side rails (3) in the
direction as demonstrated in FIGURE 1.
2. Connect the seat side rails (3) to the tree blade (4) using four
1/4-20 x 2-1/4 IN bolts (19) and four 1/4-20 nuts (15). SEE FIGURE 2.
11
3
3
19
4
15
TOOLS NEEDED: two 7/16 IN wrenches.
