Check for parts online at www.HuntRiversEdge.com or call 800-345-6007
13
Operator’s Manual
Landmark
™
600 Blind
DETAIL I
DETAIL J
DETAIL K
13
12
47
14
41
38
38
DETAIL M
DETAIL L
STEP 15
STEP 16
15. Drape the roof panel (41) over the assembled
roof frame. Secure the hook and loop
attachment strips on the front and the back
of the roof panel to the strips on the front and
back wall panels and top tier of blind frame.
Adjust and redo as necessary to take out
as much slack in the fabric as possible. SEE
FIGURE 15 and DETAIL I.
Wrap the corners of the roof panel around
the corners of the frame assembly and secure
hook strip to loop. SEE FIGURE 15 and
DETAIL J.
Pull the roof panel tight by wrapping D-ring
straps around top tier of blind frame poles (4,
5). Feed the long strap through both D-rings
and back through to tighten. SEE FIGURE 15
and DETAIL K.
16. Locate the following parts: door frame top
(11), two bottom door frame parts (12, 13),
pole (14), two complete cam straps (38) (both
cam strap end and long loop end), and door
panel (47).
Slide a cam strap end onto each part (12, 13)
as shown. SEE FIGURE 16. Then slide (12,
13) into the sleeve in door panel (47) so that
snap buttons secure the parts together inside
of the sleeve as shown. SEE FIGURE 16 and
DETAIL M.
Slide door frame top (11) onto assembled
door frame bottom so that snap pins secure
the parts together. SEE FIGURE 16.
Slide pole (14) into top sleeve of door panel
being sure to also slide on the two long
loop ends of cam straps (38) as shown. SEE
FIGURE 16 and DETAIL L.
41
47
38
14
12
13
38
13
11
