Check for parts online at www.HuntRiversEdge.com or call 800-345-6007
5
Operator’s Manual
Landmark
™
600 Blind
1
7
ASSEMBLY INSTRUCTIONS
IMPORTANT ASSEMBLY TIP:
Do not tighten any nut and bolt combinations completely
until instructions indicate to. Finger tighten plus one turn of
a wrench only! This will temporarily hold the lock- nut on the
bolt while helping alignment of all parts!
STEP
1
STEP 2
1. Open box, remove contents and organize all
parts together according to their labels. This
step greatly helps the ease of assembly.
Locate the four base hubs (1), three (6) poles,
three (7) poles, one (31) pole, one (32) pole
and two door hubs (9). SEE FIGURE 1.
Slide each (7) pole into the corresponding
(6) pole so that the snap button secures both
parts together. SEE FIGURE 1.
Slide the (32) pole into the corresponding
(31) pole so that the snap button secures
both parts together. SEE FIGURE 1.
Slide the two door hubs (9) down to the
second snap pin in assembled (31, 32) poles
as shown so that the snap buttons secure the
parts together. SEE FIGURE 1.
Slide the three assembled (6, 7) poles and
one assembled (31, 32) poles into the four
base hubs (1) so that the snap buttons secure
the parts together. You should now have the
bottom tier frame of the blind assembled.
SEE FIGURE 1.
2. Slide the four (18) poles into the base hubs
(1) so that the snap buttons secure the
parts together. SEE FIGURE 2.
Slide the (15) pole and (17) pole into the
door hubs (9) so that the snap buttons
secure the parts together. SEE FIGURE 2.
Be sure that the door stop plate on pole
(15) is facing interior of blind as shown in
DETAIL A.
7
6
9
32
31
6
6
7
DETAIL A
18
1
17
9
15
Door
stop plate
7
6
7
6
1
9
32
6
31
7
18
17
1
15
9
