Check for parts online at www.HuntRiversEdge.com or call 800-345-6007
6
Operator's Manual
Landmark
™
600 Blind
18
2
17
15
30
23
24
56
49
22
23
24
23
24
56
49
STEP 3
STEP 4
3. Attach the four middle hubs (2) to the (18)
poles so that the snap buttons secure the
parts together. SEE FIGURE 3.
Attach the two (30) parts to the middle hubs
(2) and the (15) and (17) poles as shown. The
end that attaches to the middle hub does not
attach with a snap button and will be secured
together with hardware in a later step. SEE
FIGURE 3.
Slide each (24) pole into the corresponding
(23) pole so that the snap button secures
both parts together. SEE FIGURE 3.
Slide the three assembled (23, 24) poles
into the four middle hubs (2). These do not
attach with snap buttons and will be secured
together with hardware in a later step. You
should now have the middle tier frame of the
blind assembled. SEE FIGURE 3.
4. Attach each of the eight (22) poles to the
bottom and middle tiers of the blind frame
using two 1/4-20 X 1-1/2 IN bolts (49) and
1/4-20 nuts (56). SEE FIGURE 4.
Pay attention
to the orientation of the bolts! The head of
the bolt must be on the outside of the frame.
This helps prevent wear on the skin when fully
assembled.
STEP 5
2
24
18
23
24
23
17
30
24
23
15
49
56
22
49
56
