To remove the drawer:
A. Pull the drawer fully open so the black latch is visible in the inside channel of the guides.
B. Release the latches by simultaneously pushing one lever up and the other down.
C. At the same time, pulling the drawer forward until the slides release. If necessary,
empty drawer before removing.
To Reinstall Drawer:
A. Carefully reinstall the drawer by aligning the channels on the drawer with the ball
bearings in the channels of the cabinet members and gently pushing the drawer closed.
B. Carefully open the drawer to verify it is working properly.
To release
drawer slide
Rail Hook
Clip
Clip
Fixing Screw
To Remove Drawer
A. Pull the drawer fully open (remove the fixing screws if required).
B. Simultaneously push the black plastic clip on both rails "in" and hold in place.
C. At the same time, lift the drawer and pull forward to disengage the rail from the slide.
To Reinstall Drawer:
A. Engage rail with the hook at the end of the slide.
B. Lower drawer and allow the clip to pass through the opening in the rail.
C. A "click" will be heard as the clip locks.
D. Replace fixing screw if required.
Steps For Removing Drawers Equipped
With Ball-Bearing Side Guides.
Drawer Removal (cont.)
All file drawers will be equipped with one
of the two guide types depicted below.
Page 4 of 4
FURNITURE
Riverside
email: info@riverside-furniture.com
