Made in Viet Nam
Page 2 of 2
Assembly Instructions
Corinne
Bed Room
email: info@riverside-furniture.com
FURNITURE
Riverside
21574 4/6-5/0 Poster Headboard
21575 5/0 Poster Footboard
21572 5/0-6/6 Bed Rails
5/0 Queen Bed
ASSEMBLY STEPS :
To prevent possible damage to furniture and personal injury,
it is recommended that two people are used to perform the
following steps.
5. Install two All-Thread Bolts (R-B) into the metal threaded
inserts installed in the completed Headboard Legs and into
the metal inserts on the completed Footboard.
6. Carefully position one end of one Bed Rail (R-A) onto the
All-thread Bolts on the Headboard and connect using the
Curved Washers (R-E), Spring Washers (R-D), and Hex
Nut (R-C). Only partially tighten the Nuts until the
Footboard has been connected. Repeat for other Bed Rail.
7. Position and connect the completed Footboard (F-A) to the
other end of the Bed Rails, attaching as in the previous Steps.
8. Carefully align the Footboard to be 'square' with the
Headboard. Using the Open Wrench (R-F) tighten all Hex
Nuts attaching the Side Rails to the Headboard and
Footboard. (See Detail E).
9. Attach the four Support Legs (F-C) to the bottom side of
four Wood Slats (F-B). (See Detail F).
10. Position and attach the Slats to the Bed Rails using the
Wood Screws (F-D) and your Phillips Screwdriver.
The levelers located at the bottom of the Support Legs can be
adjusted if necessary to support the Slats.
