A
E
H
B
C
B
Be sure to check all packing material carefully for small parts, which may have come loose inside the
carton during shipment.
To prevent possible scratches or damage, this furniture should be assembled on a
soft surface such as a blanket or carpet.
ASSEMBLY STEPS:
1.
Place the Headboard Panel (A) face down on the soft surface.
2. Attach the Left and Right Legs (B) to the back of the Headboard Panel using the Allen-Head Bolts (E),
Spring Washers (F) and Flat Washers (G). Do not fully tighten Bolts until after next step.
3. Attach the Stretcher (C) to the Legs as shown using the Bolts (D) and Washers as before.
4. Adjust parts for correct fit if necessary and tighten all Bolts using the Allen Key (H).
5. Carefully lean the assembled Headboard against the wall where the bed will be used.
Note: There are levelers installed in the bottom of the Posts which can be adjusted if needed, to align the
Headboard with the Nightstands.
Left
Right
21872 QN LOW UPH HDBD
Precision
Queen Bed
Assembly Instructions
Made in Viet Nam
email: info@riverside-furniture.com
Page 2 of 6
