Page 6 of 7
Windward Bay
Bedroom
Assembly Instructions
Made in Viet Nam
email: info@riverside-furniture.com
FURNITURE
Riverside
ASSEMBLY STEPS :
To prevent possible damage to furniture and personal injury, it is recommended that two people are used
to perform the following steps.
5. Install two All-Thread Bolts (R-B) into each metal plate installed onto the Headboard Posts and into the
metal plates on the Footboard.
6. Carefully position one end of one Bed Rail (R-A) onto the All-thread Bolts on the Headboard and
connect using the Flat Washers (R-E), Spring Washers (R-D), and Hex Nut (R-C). Only partially tighten
the Nuts until the Footboard has been connected. Repeat for other Bed Rail.
7. Position and connect the Footboard (F-A) to the other end of the Bed Rails attaching as in the previous
Steps.
8. Carefully align the Footboard to be 'square' with the Headboard. Using the Open Wrench (R-F) tighten
all Hex Nuts attaching the Side Rails to the Headboard and Footboard. (See Detail E ).
9. Attach the eight Support Legs (F-E) to the bottom side of Wood Slats (F-F). (See Detail F).
10. Position and attach the Slats to the Bed Rails using the Wood Screws (F-L) and your Phillips
Screwdriver.
The levelers located at the bottom of the Support Legs can be adjusted if necessary to support the Slats.
8 pcs.
4 pcs.
