Riverside Hydronics TempTrac, Service & Setup Manual

Page 6/ 24 

34-81  10/2013 

3.3 

UPPER LED READOUT (RED) 

The default display of this readout is the temperature sensed at Probe 2, which is generally the supplied outlet 

water temperature. Probe 2 may display the tank stored water temperature, flue gas temperature, ambient 
temperature, remote tank, blended water temperature, etc., depending on the product and application. Refer to 
your specific product’s Installation and Maintenance Manual and the supplied wiring drawing. The upper LED 
readout can also be switched to display Probe 1 or 3(if used) or the modulation % or the temperature difference 
between Probe 1 and 2. If set to display Probe 2, and Probe 2 is not utilized, the display will show “

nu

”. 

By pressing and releasing the 

 button once, the Upper LED will display the actual temperature sensed at 

Probe 3. Probe 3 (if used) may display the flue gas temperature or outside ambient temperature, etc., 
depending on the product and application. 

By pressing and releasing the 

 button again, the Upper LED will display the modulation %. If the product is 

a non-modulating product, the displayed valve should not be considered. 

By pressing and releasing the 

 button a third time, the Upper LED will display the difference between the 

temperature sensed at Probe 2 (generally the outlet temperature) and the temperature sensed at Probe 1 
(generally the inlet temperature). 

To return to the default in the Upper LED readout, press the

 button to cycle back to the Probe 2 

temperature. 

All of the display information described above is available for monitoring through the optional MODBUS RTU 

interface. 

3.4 

LOWER LED READOUT (YELLOW) 

The default display of this readout is the temperature sensed at Probe 1, which is generally inserted into the 

return inlet piping of the boiler. Probe 1 may display the tank stored water temperature, supplied outlet water 
temperature, flue gas temperature, ambient temperature, remote tank or blended water temperature, etc., 
depending on the product and application. Refer to your specific product’s Installation and Maintenance 
Manual and the supplied wiring drawing. The lower LED readout can also be switched to display Probe 2 or 
3(if used) or the modulation % or the Time of Day. 

By pressing and releasing the 

 button once, the Lower LED display will show the Time of Day. Press again 

to return to default display. 

3.5 

TO SET THE CURRENT TIME AND DAY (24 HOUR CLOCK)  

1.  Push and hold the 

button for more than 3 seconds. The 

LED ICON starts flashing and the “Hur”

(hour)

parameter name is displayed in the Upper LED readout

, 

its value is displayed in the Lower LED readout

.

2. Pushing the 

 or 

 button alternates the LED readouts between the following:  



  “Hur” (hour) in the Upper readout and its value in the lower readout. 



  “Min” (minute) in the Upper readout

, 

its value in the Lower readout. 



  “dAY” (day) in the Upper readout

, 

its value in the Lower readout. 

3.  To adjust a value, press the 

button and the value in the Lower LED will start flashing. Change the value by 

pressing the 

or

buttons. When correct, press 

.

4.  To exit push 

 + 

 or wait 15 seconds without pressing any buttons. 

NOTE

: This device recognizes Sunday as the first day of the week and Saturday as the last.