WWW.RSIWW.COM
20 of 45
G-1
G-1
G-2
G-2
G-2
G-2
NOTE: VIEWS FROM INSIDE.
NOTE: VIEW FROM INSIDE.
NOTE: At front and back, edge of G-1 gutter
profile lines up flush with edge of F-7 corner profile.
Prepare two G-1 gutter profiles by sliding four T-bolts into bottom bolt track.
Hand tighten each end T-bolt to hold in place.
Prepare three G-2 gutter profile with six T-bolts and the other G-2 gutter
profile with five T-bolts. Slide T-bolts into bottom bolt track.
Hand tighten end T-bolt to hold in place.
Working from inside, place G-1 and G-2 gutter profiles, fitting top edge of W-1 panels into
channels of gutters. Place one short G-1 gutter profile at each end and the four longer
G-2 gutter profiles in the center. Seams
are centered to bolt tracks in F-1 profiles.
Place one T-bolt on the inside bolt track of the gutter
at each end. Hand tighten both T-bolts to hold in place.
4.3A
4.3B
4.4A
4.4B
S-7
31
QTY
Profile
2
G-1
G-2
4
25½”
48½”
G-1
F-7
W-1
W-1
W-1
W-1
F-7
F-1
F-1
G-1
G-2
G-1
W-1
F-7
F-7
G-1
W-1
S-7
2
NOTE: In some cases a ¼” x ¼” notch
in top corner of W-1 panel will provide
a better fit for G-1 gutter profile.
¼”
¼”
