WWW.RSIWW.COM
26 of 45
IMPORTANT: Bolt track of F-6 front profile is
lower than bolt track of G-1 gutter profile.
WARNING: The corners of W-3 panels are
sharp. Use extreme caution when handling.
WARNING: The corners of W-5 panels are
sharp. Use extreme caution when handling.
Working from inside, remove plastic film from both sides
of two W-3 panels. Fit each panel into
channels in profiles, placing side
marked “ UV Resistant”
facing outside.
Continue working from inside. Position door frame so
barrel latch is on outside. Loosen set
screws on ends of F-5 profile
and adjust position to fit
holes in B-2 connector.
Secure with two bolts.
Ensure height to base
is 68¾”.
Remove plastic film from both sides of two W-5 panels. Fit each panel into
channels in profiles, placing side
marked “ UV Resistant”
facing outside.
From inside, add connectoaB-7 to each corner. Secure each with two S-2C caps.
5.5A
5.5B
5.5c
5.6
5.7
NOTE: VIEWS FROM INSIDE.
NOTE: VIEWS FROM INSIDE.
NOTE: VIEWS FROM INSIDE.
W-3
W-3
B-2
F-5
B-2
B-2
F-5
S-2C
2
Connector
QTY
W-3
2
Panel
QTY
24” x 15
½”
W-5
W-5
W-5
2
Panel
QTY
24” x 18
½”
F-6
F-6
G-1
F-7
B-7
B-7
S-2C
4
2
Connector
QTY
