INTRODUCTION
Rivtec
®
RT-C2 Air Hydraulic Rivet Tool is a high performance economical air hydraulic rivet tool.
It utilises a lightweight ergonomic design and installs rivets from Ø3.2mm to Ø6.4mm (steel).
SPECIFICATIONS
Weight .............................................. 1.15kg
Pulling Force .......................................10KN
Air Pressure .................................... 5-7 bar
Stroke ................................................18mm
PACKAGE ACCESSORIES
■
RT-C2 Rivet Tool
■
Operator’s Manual
■
Nosepiece for 3.2mm rivets
■
Nosepiece for 4.0mm rivets
■
Nosepiece for 4.8mm rivets
■
Nosepiece for 6.4mm rivets
■
Spare Jaw Case
■
Spare Jaws (set of 3)
■
Spare Jaw Spreader & Spring
■
Syringe
■
3mm Hex. Key
TOOL DIMENSIONS
124 mm
Ø 102 mm
292 mm
Ø 23 mm
64 mm
285 mm
Ø 54 mm
2
SAFETY INSTRUCTIONS
Caution!
To ensure proper functioning and safe operation, read this Operator’s
Manual carefully before operating the RIVTEC® RT-C2 tool
■
The rivet tool should be used exclusively to set blind rivets.
■
DO NOT overload the tool – work within the prescribed work capacity
■
ALWAYS wear eye protection when working with the tool. Personal protection such as
clothes, gloves, safety helmet, non-slipping shoes, ear protectors and protection against
fall are highly recommended.
■
This tool is NOT designed for use in explosive atmospheres.
■
DO NOT use the tool as a hammer.
■
Ensure the tool is not damaged before connecting to the air supply.
■
Repair work must be carried out by trained personnel. In case of doubt, ALWAYS send
back the tool to the supplier.
■
ALWAYS disconnect the air supply when adjusting, servicing or removing any part of the
tool.
■
Keep fingers off the trigger when connecting the air supply or if the air supply fails.
■
Keep fingers away from the front of the tool when connecting the air supply or setting
rivets.
■
DO NOT point the tool at anyone.
■
DO NOT operate tool with the nose housing removed.
■
DO NOT operate tool without the mandrel collector.
■
DO NOT modify the tool in any way. Modification could damage the tool.
■
The operating pressure must not exceed 7 bar.
■
DO NOT direct tool exhaust towards anyone.
■
Wash hands if exposed to hydraulic fluid or lubricant.
■
Keep hair, fingers and loose clothing away from moving parts of the tool.
3
