8.
Place the Tarp Back (22) over the arch of the back End Bow and wrap the material
around the arch while bringing the slits to the inside of the frame. Place the End Top Rail
(11) at the Top Crest (12) into the slit.
See Figure 9 on the previous page.
9.
Once the End Top Rails (11) are into the slits on the sides and top, put the Bolts (14) and
Nuts (16) back into all the places that they were removed and tighten them down.
See
Figure 9.
10.
There are extra slits in the Tarp Back (22) for the Support Braces (10a+b). Repeat the
steps as before for the sides with the Support Braces replacing the exact hardware.
Tighten.
See Figure 9.
11. Notice the black rope hanging out of the bottom of the Tarp Back (22) on both sides.
With two people, wrap the rope under the Corner Feet (4). Both of you are to pull up at
the same time to tighten the door. When Tarp Back is snug, tie of the rope to the Corner
Feet (4).
12. Attach the side of the Tarp Back (22) to the frame by using the 6 pcs. Ball Tie Downs
(24).
TARP COVER INSTRUCTIONS
1. Position the Tarp Cover (23) face side up, being aware of length and height of RV Shelter
frame in reference to the length and width of the Cover. Lie the Tarp Cover along the side
of the frame. Fold in half lengthwise. Position the folded Tarp as close to the frame as
possible. Attach long ropes (not provided) in holes on each end of the Tarp. These ropes
will be used to guide and pull the Tarp Cover (23) over the top of the frame.
Figure 10.
SKU 103-1642
Page 10
Figure 10
Summary of Contents for RV SHELTER 103-1642
Page 15: ......
