STEP 11
STEP 11
OPEN BAG 9 INSTALL THE PINION GEAR ONTO THE
MOTOR YOU HAVE CHOSEN. INSTALL THE MOTOR WITH TWO
M3 SCREWS AND WASHERS. MAKE SURE THE PINION IS LINED
UP WITH THE AXLE GEAR, ADJUST THE MOTOR SO THERE IS A
SMALL AMOUNT OF PLAY IN THE GEARS , AND TIGHTEN THE
SCREWS. TURN THE AXLE A COUPLE OF TIMES TO RECHECK.
STEP 12
STEP 12
OPEN BAG 7 PRESS A BUSHING INTO EACH SIDE OF
EACH FRONT WHEEL AND STRETCH AN O-RING ON EACH ONE.
PUT A SMALL DROP OF LIGHT OIL ON EACH FRONT AXLE , IN-
STALL THE WHEELS AND RETAIN WITH E-CLIPS.
STEP 13
STEP 13
INSTALL THE REAR TIRES FROM BAG 8 WITH TWO
3/8 CAP SCREWS EACH FROM BAG 4.
STEP 14
STEP 14
ATTACH YOUR STEERING SERVO TO THE CHASSIS
WITH SERVO TAPE, POSTS, OR SCREWS IF YOUR SERVO HAS
SIDE MOUNTS. INSTALL PREBENT LINKS AND ATTACH WITH 1/8
COLLARS AND SETSCREWS. CUT THE LENGTH OF THE LINKS
AS NECESSARY.
STEP 15
THIS STEP SHOWS HOW TO MOUNT A SMALL SERVO
AND MICRO SWITCH ON THE SWITCH PLATE. YOU MAY NEED A
SERVO WIRE EXTENSION IF YOURS WON’T REACH THE AREA IN
FRONT OF THE RIDE HEIGHT POST WHERE YOU SHOULD
MOUNT THE RECEIVER. IF YOU CHOOSE TO USE AN ESC , YOU
CAN MOUNT IT ON THE SWITCH PLATE OR ON THE CHASSIS
NEAR THE RCVR. THE SWITCH SHOWN IS A MICRO SWITCH
BRAND 25 AMP, AVAILABLE AT MOST ELECTRONIC STORES.
STEP 15
STEP 16
INSTALL YOUR BATTERY PACK AT THE REAR OF
THE CHASSIS WITH TIE STRAPS INCLUDED. INSTRUCTIONS
FOR WIRING A CAR WITH A MICRO SWITCH ARE INCLUDED.
OTHERWISE WIRE YOUR RADIO AND ESC ACCORDING TO
THE MANUFACTURER’S INSTRUCTIONS.
STEP 16
3
