STEP 6
USE TWO 1/2” CAP
SCREWS AND A 1/2” NYLON
SPACER TO ATTACH THE
REAR BARS TOGETHER.
STEP 8
OPEN THE STEERING BAG FROM BAG H1 AND THREAD A
JAM NUT ON EACH 5377 KINGPIN, INSERT INTO EACH END OF THE
FRONT AXLE PLATE, AND ADD A 7207 LOCKNUT ON EACH ONE.
STEP 9
PRESS A 5364 STUB
AXLE INTO EACH 5351 STEER-
ING BLOCK AND RETAIN WITH A
5221 E-CLIP.
STEP 10
LUBE EACH KINGPIN,
SLIDE THE STEERING BLOCK
ON, ADD A 5228 SPRING ,
WASHER , AND E-CLIP.
STEP 11
INSTALL YOUR
SERVO SAVER ON THE SERVO
AND ATTACH THE SERVO UN-
DER THE SERVO PLATE WITH
FOAM TAPE PROVIDED. GET
THE SERVO SAVER AS CLOSE
TO THE CENTER AS POSSIBLE.
2
STEP 7
ATTACH THE LONG
A-ARM TO THE RIGHT SIDE
AND THE SHORT ONE ON
THE LEFT OF THE FRONT
AXLE CENTER.
USE THE 1/4”(SHORT)
SCREW THROUGH THE
FRONT HOLE IN THE CEN-
TER AND THREAD IT INTO
THE A-ARM. INSTALL THE
LONGER SCREW AND NUT
IN THE REAR HOLE.
YOU CAN INSTALL THE A-ARMS ON TOP OF THE CENTER TO LOWER THE
FRONT RIDE HEIGHT OR ONE ABOVE AND THE OTHER BELOW TO PRELOAD
ONE SIDE FOR OVAL RACING.
STEP 12
INSTALL THE STEERING LINKAGE FROM BAG H3. INSTALL
A LONG LINK IN EACH STEERING BLOCK AND TWO SHORT ONES IN
THE SERVO SAVER. USE THE COLLARS AND SET SCREWS TO AT-
TACH THE RODS TOGETHER AFTER ALIGNING THE STEERING. YOU
MAY HAVE TO REMOVE THE LEFT STEEERING BLOCK, ATTACH THE
LINKAGE, AND RE-INSTALL IT.
MAKE SURE TO WIPE THE SERVO AND THE FRONT AXLE PLATE
WITH A DRY CLOTH BEFORE APPLYING THE SERVO TAPE.
STEP 13
INSTALL THE 5188 RIDE HEIGHT ADAPTORS
FROM BAG G2 AND ADD THE 5452 REAR BUSHINGS.
STEP 14
SNAP A DIFF BALL INTO EVERY OTHER HOLE
IN THE OUTSIDE ROW OF THE GEAR. LUBE EACH ONE
WITH A LITTLE THICK SILICONE OR GREASE.
