RJ Speed Speedway Sprinter, Quick Start Manual

STEP 21 

 OPEN BAG H1A. MOUNT THE ROLL CAGE SIDES TO 

THE CHASSIS WITH 3/8 BUTTON HEAD SCREWS. USE THE 
1/4” (SHORT) SCREWS IN THE  FRONT HOLES. ADD THE JAM 
NUT FROM BAG A  AT THE REAR OF THE TIE BAR. 

4 

STEP 22 

 USE 1/2” BUTTON HEAD SCREWS AND THREE 

CHASSIS SPACERS TO ATTACH THE TWO SIDES OF THE 
ROLL CAGE TOGETHER.  

STEP 23 

 PAINT THE HOOD AND TAIL TANK PARTS AND 

THE SIDE PANELS AND TRIM THEM OUT AS SHOWN BY 
THE TRIM LINES ON THE PARTS. DRILL THE HOLES 
MARKED WITH A 1/8 “ DRILL TO MOUNT THEM TO THE 
CHASSIS. THE TWO HOLES IN THE SIDES OF THE TAIL 
TANK SNAP OVER THE TWO SCREWS THAT HOLD THE 
REAR OF THE ROLL CAGE TO THE CHASSIS AND YOU 
WILL NEED TO REMOVE THE BOTTOM SCREW THAT 
HOLDS THE LOWER REAR BAR TO THE 1/2” SPACER TO 
ATTACH THE REAR OF THE TAIL TANK. 

STEP 24 

 TO MOUNT THE SIDE PANELS, 

LOOSEN THE SCREWS THAT HOLD THE FRONT 
OF THE NERF BARS AND REMOVE THE  
SCREWS THAT ATTACH THE CENTER OF THE 
ROLL CAGE TO THE CHASSIS. SLIDE THE SIDE 
PANEL OVER THE REAR OF THE NERF BAR AND 
BETWEEN THE FRONT OF THE NERF BAR AND 
THE CHASSIS. TIGHTEN THE FRONT NERF BAR 
SCREW AND REPLACE THE  SCREW TO HOLD 
THE SIDE PANEL IN PLACE. REPEAT FOR THE 
OPPOSITE SIDE. TO INSTALL THE HOOD, SLIDE 
IT BETWEEN THE CAGE SIDES AND SPREAD IT 
OUT SO IT WILL GO OVER THE SIDE PANEL 
FLANGES. TRIM SLIGHTLY IF NECESSARY. YOU 
CAN USE TAPE OR VELCRO TO HOLD THE REAR 
OF THE HOOD OVER THE CHASSIS BRACE IF 
NEEDED. 

DRILL 

BEND REAR EDGE UNDER SLIGHTLY