Rudder and Throttle Servo Adjustments
1.Checking the servo rotation.
With the radio transmitter and receiver switched on, move the rudder and throttle sticks, and check that each servo moves in the correct direction. If
either servo moves in the wrong direction, it will be necessary to reset that servo using the appropriate reversing function on your transmitter.
2.Travel Adjust.
Travel Adjust settings are changed in conjunction with the settings in the flybarless system settings.
NOTE:
Try to get the mechanical set up as close possible to the values given in this manual and you will find that final trimming will be so much easier.
Using the transmitter to correct a poor mechanical set up will result in a model that is very difficult to trim and fly.
STEP 7-1 FINAL SERVO AND RADIO SETUP
3. Sub trim Function
When the rudder stick and trim are in their mid position make sure that the
servo horn and tail control rod are at 90º as shown next. If you cannot
achieve the desired servo arm position use the sub trim function to make
minor adjustments.
NOTE:
lt is necessary to keep the sub trim values as close to zero as
possible to make final setting up simple.
Correct ATV
Incorrect ATV
100%
100%
100%
50%
0%
0%
90º
90º
90º
R1
