2.PROCEDURE FOR SETTING
4
IMCB10-E1
2. PROCEDURE FOR SETTING
If the instrument is changed to initialization mode, the symbol (Cod) for selecting the initialize code is
displayed first. (Initializing items are classified into 3 initialize code groups in initialization mode.)
Enter the initialize code corresponding to the parameter to be chanted, and then select the parameter
to be changed by pressing the SET key. The measured value (PV) display unit shows the characters
corresponding to the parameter, and the set value (SV) display unit shows the value corresponding to
that parameter. Display flowcharts in initialization mode are shown in the following.
2.1 Display flowcharts in initialization mode
There are parameters which are not displayed depending on the
specification.
PV/SV display mode
(SL1)
Parameter setting mode
Communication setting mode
Keep pressing the SET and <RST keys simultaneously
for 2 sec with the set data unlocked.
Explaining the arrow mark :
Press the SET and <RST keys
simultaneously for 2 sec.
Press the SET key.
Set to 0.
Input type selection
Engineering unit
selection
Action selection at the
time of reset key
operation
Alarm 1 type selection
Alarm 2 type selection
Limit action type
selection
Special specification
selection 1
Special specification
selection 2
Unused
Option selection
For manufacturer's
[RKC's] own use
Setting limiter
[high limit]
Setting limiter
[low limit]
Setting the position of
decimal point
Differential gap setting
of alarm 1 (ALM1)
Differential gap setting
of alarm 2 (ALM2)
Holding peak ambient
temperature
Operating time display
unit (Upper digits)
Operating time display
unit (Lower digits)
Parameters in this initialize code
are only displayed.
(SL2)
(SL3)
(SL4)
(SL5)
(SL6)
(SL7)
(SL8)
(SL9)
(SL10)
(SL11)
(SLH)
(SLL)
(PGdP)
(AH2)
(AH1)
(TCJ)
(WTH)
(WTL)
Initialize code selection
Initialize code selection
Set to 1.
Set to 2.
Press the SET key
for 2 sec.
Press the SET and <RST keys simultaneously.
CAUTION