1. TRANSFER TO MODE
IMCB10-E1
3
1.2 End of initialization mode
c
Transfer to "initialize code selection" after each parameter is set.
d
Simultaneously keep pressing both the SET and <RST keys for 2 sec in the "Initialize code
selection" state to transfer to "PV/SV display mode."
e
Press the SET key for 2 sec in the "PV/SV display mode" state to transfer to parameter setting
mode.
f
Press the SET key to transfer to the set data lock function display.
g
Press the <RST key to brightly light the thousands digit on the set value (SV) display unit.
(See
f
on P.1)
h
Press the DOWN key to set the numeric value corresponding to the thousands digit to "0" from "1."
i
Press the SET key to transfer to the next parameter. As a result, the "Initialization mode lock state"
setting becomes effective.
After the controller terminates the initialization mode, the limit action output is set to
the ON state in the same way as at the time of power ON.
RST
RST
RST
RST
SET
SET
SET
SET
SV
SV
SV
SV
PV
PV
PV
PV
ALM2
ALM1
OUT
EXCD
RST
RST
RST
RST
SET
SET
SET
SET
SV
SV
SV
SV
PV
PV
PV
PV
ALM2
ALM1
OUT
EXCD
Set data lock function
Set value
0 : Initialization mode locked
1 : Initialization mode unlocked
Bright lighting :
Dim lighting :
Alarm 1 setting value
*In the left figure, the alarm 1 setting value is displayed.
However, the parameter to be displayed varies
depending on the specification.
NOTE