9. OPERATION
IMR01N12-E7
117
9.
Press the SET key to store the new value. The display goes
to the next parameter.
10.
Set the Memory area 2.
Press the SET key several times until Input 1_setting
change rate limiter (up) setting screen is displayed.
11.
Press the shift key until the memory area display unit is
high-lighted.
12.
Press the UP key to change to 2. Area number display
flashes.
13.
Press the shift key to high-light the least significant digit.
14.
Press the UP key to change the number to 5.0.
15.
Press the SET key to store the new value. The display goes
to the next parameter. Check that this screen is set to OFF.
16.
Press the SET key until Area soak time setting screen is
displayed.
17.
Press the shift key to high-light the most significant digit.
18.
Press the UP key to change the number to 6.
19.
Press the SET key to store the new value. The display goes
to the next parameter.
20.
Press the UP key to change the number to 3.
21.
Press the SET key to store the new value. The display goes
to the next parameter.
22.
Set the Memory area 3.
Press the SET key several times until Input 1_setting
change rate limiter (up) setting screen is displayed.
Continued on the next page.
AREA
(Example: Event 1 set value setting screen)
AREA
AREA
High-light
Factory set value:
OFF (Unused)
Memory area No. 2
AREA
Flashing
AREA
Factory set value:
0.00.00 (0 min. 00.00 sec.)
AREA
Flashing
AREA
Flashing
AREA
Flashing
AREA
Flashing
(Example: Event 1 set value setting screen)
AREA
Flashing
AREA
Flashing
AREA
Flashing
Factory set value:
OFF (No link)
AREA
Flashing
High-light
Link area number setting screen
Factory set value:
OFF (Unused)
Flashing
AREA
Input 1_setting change rate limiter
setting (down) setting screen