4. SETTING
24
IMR01N12-E7
4.2 Operation Menu
The controller has five different setting modes. All settable parameters belong to one of them. The following
chart shows how to access different setting mode.
For the details of key operation, refer to
4.3 Key Operation
.
(P. 26)
* From the Operation mode and the Parameter setting mode,
the display is returned to the SV setting & Monitor mode
by pressing the shift key while pressing the SET key.
Power ON
Input type/Input range Display
SV setting & Monitor mode
-
Set or change Set value (SV).
-
Monitor parameters such as PV, SV
and MV.
-
Conduct operation in this mode.
Parameter setting mode *
-
Change parameters related to control such
as PID values.
-
Up to 16 individual sets of parameters in
Parameter setting mode and SVs can
be stored and used in Multi-memory
area
function.
Setup setting mode
Set setting items not being in the Memory area,
and Lock levels.
Operation mode *
-
Change Operation status/mode such as
PID/AT, Auto/Manual, and Remote/Local.
Engineering mode
-
Change basic control functions such as
Input/Output assignment.
Press and hold the SET
key for 2 seconds
Press and hold the SET
key for 2 seconds
Press the
shift key
while
pressing the
SET key
Press and hold the shift
key for 1 second
Press the shift key
while pressing the
SET key
Press the shift key
while pressing
the SET key for
2 seconds
This instrument returns to the PV1/SV1 monitor screen if no key
operation is performed within 1 minute.
Any parameter which is not used in the controller will not be
displayed except for parameters in Engineering mode.
The parameters in Engineering mode
which should be set according to the
application are settable only when the
controller is in STOP mode.
(Refer to P. 30)
(Refer to P. 101)
(Refer to P. 50)
(Refer to P. 32)
(Refer to P. 42)
