5. SV SETTING & MONITOR MODE
IMR01N12-E7
31
5.2 Procedure for Set Value (SV) Setting
Up to 16 individual sets of SVs and parameters in Parameter setting mode can be stored and used in
Multi-memory area function. Some examples of changing the Set value (SV) described in the following. The same
setting procedure applies when parameters corresponding to the Multi-memory area function are also set.
Change the Set value (SV)
Change SV1 of Input 1 from 0.0 MPa to 200.0 MPa:
1.
Press the SET key several times at PV1/SV1 monitor screen
until Input1_SV1 setting screen is displayed.
2.
Press the shift key to high-light the hundreds digit.
The high-light digit indicates which digit can be set.
3.
Press the UP key to change the number to 2.
4.
Press the SET key to store the new value. The display goes
to the next parameter.
(Example: Input 2_SV2 setting screen)
Change the Set value (SV) of another Memory
area which is not selected for ongoing control
While Memory area 1 is selected for ongoing control,
change SV1 of Input 1 in Memory area 3 from 150.0 MPa to
100.0 MPa:
1.
Go to Input 1_SV1 setting screen. Press the shift key until the
Memory area display unit is high-lighted.
The high-lighted digit indicates which digit can be set.
2.
Press the UP key to change to 3. The SV display shows the
Set value (SV1) of Input 1 of the Memory area 3, and the
number in AREA (Area number) display flashes.
3.
Press the shift key to high-light the tens digit.
The Area number is flashing.
4.
Press the DOWN key to change the number to 0 in the tens
digit.
5.
Press the SET key to store the new value. The display goes
to the next parameter.
(Example: Input 2_SV2 setting screen)
AREA
AREA
AREA
AREA
AREA
AREA
AREA
AREA
AREA