EAGLE 2 Operator’s Manual
Using Setup Mode • 111
3. Use AIR
▲
YES or RANGE
▼
SHIFT to display the desired setting.
4. Press and release POWER ENTER RESET to save the setting and return to the main
menu.
Updating the Data Log Interval Setting
This setting indicates how often the EAGLE 2 saves readings to the data logger. The
following interval times can be selected: 10 minutes, 5 minutes, 3 minutes, 1 minute, 30
seconds, 20 seconds, 10 seconds, or 5 seconds. The factory setting is 30 seconds.
1. From the main menu, place the cursor next to
DATA LOG
INTERVAL
.
2. Press and release POWER ENTER RESET. The Data Log Interval Screen appears.
3. Use AIR
▲
YES or RANGE
▼
SHIFT to display the desired setting.
4. Press and release POWER ENTER RESET to save the setting and return to the main
menu.
Updating the Data Log Overwrite Setting
With
DATA LOG OVERWRITE
set to
ON
(factory setting), the EAGLE 2 writes over
the oldest data with new data when the data logger memory is full.
With
DATA LOG OVERWRITE
set to
OFF
, the EAGLE 2 stops saving data to the data
logger when the data logger memory is full.
1. From the main menu, place the cursor next to
DATA LOG OVERWRITE
.
2. Press and release POWER ENTER RESET. The Overwrite Log Data Screen appears.
3. Use AIR
▲
YES or RANGE
▼
SHIFT to display the desired setting.
4. Press and release POWER ENTER RESET to save the setting and return to the main
menu.
DATA LOG INTERVAL
UP/DOWN THEN ENTER
30 SECONDS
OVERWRITE LOG DATA
WHEN MEMORY IS FULL?
UP/DOWN THEN ENTER
ON
www.
.com
information@itm.com
1.800.561.8187